PDS Series User Manual ( V1.4, Oct. 2009) ----- 84
Broadcast
1 = receive UDP broadcast packets
0 = reject UDP broadcast packets
Connection WDT timeout (ms): default = 0 (disabled), min. = 10000.
If the PDS series module does not receive any data from a client PC within the period
of the “Connection WDT timeout”, the module will close the connection to the client.
Network WDT timeout (ms): 0 = disabled, min. = 30000.
If the PDS series module does not receive any data from any of the clients within the
period of the “Network WDT timeout”, the module will reboot itself. The default setting
should be 300000ms (= 300 seconds).
This setting is the same as “SystemTimeout” setting (unit: ms) on Console/Telnet
command, and is the same as “/STxxx” in command line parameter (unit: seconds).
When user uses “config=RESET” Console/Telnet command to clear the EEPROM,
the “Network WDT timeout” (SystemTimeout, /ST) setting will also be cleared to 0.
Users have to configure this setting again by “SystemTimeout” Console/Telnet
command.
Master IP: default = empty (disabled).
If the Master IP is set, only the client using Master IP can change the COM Port
configuration. It is to prevent the COM Port configuration changed by other clients.
After setting the new configuration, click the “Set TCP/IP” button to save the new
settings to the PDS series module. If the “Reset System” option is checked, the PDS series
module will reboot itself after the saving operation is complete, otherwise the original
settings will still be valid until the next power-on.
Summary of Contents for PDS-700 Series
