PDS Series User Manual ( V1.4, Oct. 2009) ----- 87
The Currently Used COM Port Settings list
The COM Port Settings area
Note: If the “Set COM Port” button is clicked without checking “Apply current setting”,
option the new settings will be saved to the PDS only and the new settings will be valid
after the next power-on.
If the “Apply current setting” checked when the “Set COM Port” button is clicked, the
new settings will be valid immediately.
Port: The COM Port number on the PDS series module.
Baud Rate, Data Bits, Parity
Stops Bits, End Character:
The configuration settings should match the serial device used.
Fifo Trig. Level: FIFO trigger level
This option is used to set the number of characters that the COM Port can receive at
once time, the PDS will move the data from the COM Port FIFO to the PDS. If the amount
of data transferred is large and uses a transfer speed (115200 bps), setting a smaller value
is helpful in preventing data loss.
DBDT (ms): Data buffer delay timeout
When the COM port does not receive data from devices connected over the period of
DBDT setting, the PDS will determine that the data transfer is over and return to process
next tasks.
Summary of Contents for PDS-700 Series
