Tiny Serial-to-Ethernet Device Server
Copyright © 2020 ICP DAS CO., Ltd. All Rights Reserved.
-42 -
4.
Getting Started for DS-2200 series
This chapter provides detailed information about the “Self
-
Test” process, which is used to confirm
that the DS-2200
series module is operating correctly. Before beginning the “Self
-
Test” process, the
wiring test, Ethernet configuration and VxComm Utility driver installation procedures must first be
fully completed. Follow the procedure described below:
4.1
Connecting the Power and Host PC
1.
Ensure that the network settings on your PC are configured correctly.
Ensure that the Windows firewall or any Anti-Virus firewall software is correctly configured or
temporarily disable these functions; otherwise the
“
Search Servers
”
function in the VxComm
Utility may not work as required. You may need to contact your System Administrator for more
details of how to do this.
2.
Check that the
Init/Run switch
is in the
“
Run”
position.
3.
Connect both the DS-2200 and the Host computer to the same sub-network or the same
Ethernet Switch, and then supply power (PoE or +12 to +48 V
DC
) to the DS-2200.
PoE Power Supply
Host PC
PoE Switch(NS-205PSE)
Ethernet Cable
Power over Ethernet
Uses PoE Switch
Only ETH1 supports PoE,
ETH2 no supports PoE
