Tiny Serial-to-Ethernet Device Server
Copyright © 2020 ICP DAS CO., Ltd. All Rights Reserved.
-94 -
Appendix A: Troubleshooting
A1. How do I restore the web password for the module to the factory
default password?
The instructions below outline the procedure for resetting the web password to the factory default
value.
Note:
Be aware that
ALL
settings will be restored to the factory default values after the module is reset.
Step 1
Locate the Init/Run switch that can be found on
the right-hand side of the tDS-700/DS-2200 module and
set it to the
"Init"
position. Reboot the module to
load
factory default settings
including default web password.
Step 2
Execute either the VxComm Utility or the eSearch Utility to search for any tDS-700/DS-2200
modules connected to the network. Verify that the tDS-700/DS-2200 has been reset to the original
factory default settings. For example, the module should be shown as having the default IP address,
which is 192.168.255.1.
