WF-2571 Ethernet to Wi-Fi Bridge User’s Manual (Ver. 1.1, Oct 2013) ------------- 18
Table 3-2: Parameter configuration table of Ad-Hoc connection
mode
Wi-Fi
Connection
Mode
Ad-Hoc
：
Use Ad-Hoc connectivity with another WF-2571 to create an AD-
Hoc wireless network.
SSID
Service Set Identifier: Connected devices must be with the same SSID, SSID
length must not exceed 20 characters.
WLCH
1~13
：
Wi-Fi transmission channel setting.
When WF-2571 is configured to operate in Ad-Hoc mode, this parameter
must be given a value between 1 and 13 that defines the channel to be used
for beacon transmission. When WF-2571 joins an already existing Ad-Hoc
network, it adopts that network‘s channel.
Encryption
NONE / WEP64 / WEP128: Wi-Fi Encryption of Wi-Fi
,
connected devices
must with the same encryption.
Not Support WPA
、
WPA2 encryption in Ad-Hoc mode
。
WLK
Key of Encryption
，
connected devices must with the same Key
.
WEP-64
：
Key length must be 10 characters.
WEP-128
：
Key length must be 26 characters.
System Information:
[1] Firmware Information
After the connection is established to the WF-2571, the firmware
information will show as following Fig.
Figure 3-7: Firmware Information
[2] Signal Strength
This area will display the signal strength information by LED
indicator.
Figure 3-8:
Signal strength
display area
