ICP DAS WISE User Manual
http://wise.icpdas.com
55
DCON Master (Connect to DCON modules)
Figure 5-26
：
COM Port Interface Setting for DCON Master
The settings steps are as below:
i
In the “Baudrate” field, select the Baudrate from the dropdown list,
the Baudrate of WISE and DCON module have to be set the same.
ii
In the “Parity” and “Stop bits” fields, set up the Parity and Stop
bits. The Parity and Stop bits of WISE and DCON module have to
be set the same.
iii
In the “Timeout” field, input the time interval for WISE to send
command to the DCON module and wait for the response, the unit
will be millisecond (ms).
iv
In the “Checksum” field, specify the Checksum setting for the
communication between WISE and DCON module to be enabled
or disabled.
v
After all settings are completed, click “Save” button to save the
changes.
Please Note: Use the DCON Utility to complete the setting of each
DCON modules which will connect with the WISE first. These
setting also must be the same with the setting of WISE.
