Version 1.0.0
Page
3
Copyright © 2016 by ICP DAS Co., Ltd. All Rights Reserved.
3
Mode, Button function and LED description
WLS-T01 has two built-in modes, "Running mode" and "Setting
mode". The functions of these two modes are described as follows:
1.
Running mode: This mode is used to transmit location package
every 3 seconds in the background.
In this mode, the user can
press the button to send an alarm package or enter the setting
mode. When the pre-job(section 2) is completed, WLS-T01 will
default to the "Running Mode".
2.
Setting mode: This mode is used to transmit Node ID forcefully,
and set the RF Power and RF Channel by Button.
If the user
does not press any button for 8 seconds, the module will
automatically save and directly enable the setting value, and
then leave the "Setting Mode" to the "Running Mode".
In the above two modes, pressing different buttons will correspond
to different functions, and various functions will be indicated by the
different blinking frequency of LED. Please refer to Fig.3, Table 1 and
Table 2:
Fig 3. Product appearance
Help
Green LED
Red LED
Up
Down
Help
