31
Onboard FDC >
to enable the FDC on your board. If you set it
Auto, the BIOS will decide if the FDC should be enabled,
automatically).
Onboard Serial Port A (/B) >
to specify the I/O port address of
the serial port A(/B). If you set it Auto, the BIOS will decide the
correct I/O port address, automatically.
Serial Port B Mode >
to specify the mode of serial port B.
IR Duplex Mode >
to specify the mode of IR device that is
connected to the IR port.
IrDA Protocol >
to specify the function mode if an IrDA mode
is selected.
Onboard Parallel Port >
to specify the I/O port address of the
parallel port.
Parallel Port Mode >
to specify the mode of parallel port. The
options are:
Normal
(normal parallel port mode),
Bi-Dir
(supports bidirectional transfer),
StockCheck.com
Downloaded from StockCheck.com