Brightness: [0 ~ 63]
Adjust the Brightness of the Display on Receiver Console.
Sharpness: [0 ~ 63]
Adjust the Sharpness of the Display on Receiver Console.
Phase Red: [-31 ~ +31] specify the time delay for red colour.
Phase Green: [-31 ~ +31] specify the time delay for green colour. The blue component colour is adjusted automatically in
proportion to the red and green. Users have no need to adjust the blue colour
themselves. For a more detailed explanation of how to adjust your video display parameters on the remote console, please
refer to next section, Optimize the Video Display on the Remote Console.
EDID Setting
TX EDID
You can select the TX EDID emulation data set to adopt – either that of the monitor on the RX or the monitor on the TX unit.
You can use the Left / Right Arrow key to select. However, before you can make the selection for the first time, you might need
to read the monitor EDID information by the Read Monitor option below.
Read Monitor
Reads the EDID configuration data from the monitors on the TX and the RX & stores it for use for the EDID emulation on the TX
unit.
Password Setting
Disable / Enable the password protection feature. If enabled, after you log out or the Auto logout has timed out, you will be
prompted for the correct password before you can access the console again.