&KDSWHU$,QWURGXFWLRQ *HQHUDO,QIRUPDWLRQ
$*HQHUDO,QIRUPDWLRQ
The ICP Controller should be installed by an authorized ICP vortex distributor. Precondition
for the safe installation is an anti-static work place (earthed mat on the table with wrist
bands connected to an earth). ICP vortex does not take any responsibility for damage aris-
ing out of improper installation. This manual contains all the information available at the
time it was written. Errors and/or incomplete information are possible. We are grateful for
any ideas or suggestions for improvement. Additional information may be found in the in-
formation file
"README.GBR"
on the enclosed System Disk "DOS". Besides up-to-date
information, this file also contains a list of all programs on the ICP System Disks.
The contents of the file README.GBR must be read before the ICP Controller is used
for the first time. Output is possible on printer or screen.
This
User's Manual
explains the installation and the operation of the ICP ICP Controller.
For information on the use of the computer system and its operating system, please refer to
the corresponding system manuals. A short list of recommended literature can be found in
the appendix of this manual.
$$
88QQSSDDFFNNLLQQJ
JWWKKH
H,,&&3
3&&RRQQWWUURROOOOHHUU
Open the show box and take out the ICP Controller (leaving it in its anti-static bag), the disk
package and this manual.
WARNING: Never take the GDT PCB (Printed Circuit Board) out of the anti-static bag
unless this is done at an anti-static work place, and the person handling the ICP Con-
troller is secured with wrist bands against electrostatic charge. If these instructions
are not observed, the CMOS components on the ICP Controller may be damaged or
destroyed.
Store the show box in a safe and dry place.
$$
''HHOLOLYYHHUU\
\&&RRQQWWHHQQWWVV
The following items are delivered with the ICP Controller:
1.
ICP Controller in a sealed anti-static bag.
2.
Sealed GDT disk package with driver and installation disks.
3.
This User's Manual.
$$
&&RRQQWWHHQQWWVVRRIIWWKKH
H**''7
7''UULLYYHHUU''LLVVNNVV
A list of the files delivered with GDT can be found in the file
README.GBR
on the enclosed
GDT System Disk DOS. The contents of this file can be viewed on screen or output on your
printer. You should not use the GDT System Disks as your working disks. Use an appropri-
ate utility program (for example DISKCOPY of MS-DOS) to make functional copies of all sys-
tem disks (please observe the software license agreement). Store your original system disks
in a safe and dry place.
$$
%%HHIIRRUUH
H<<RRX
X66WWDDUUWW
In order to avoid damage caused by improper or faulty usage or handling,
we strongly rec-
ommend
reading this manual carefully before installation or first operation.
