ICP ICP Controller, Using Manual

&KDSWHU'8VHUV0DQXDO

Step 2:

 Use the ASW program AFDISK.EXE to initialize the drive to be run through the ASPI

interface.

Step 3:

 After the successful initialization, do a warm reboot (Ctrl+Alt+Del).

The CONFIG.SYS will be similar to the following (the relevant entries are printed bold):

device=gdtx000.exe

files=30
buffers=30
stacks=9,256
shell=\COMMAND.COM /E:512 /P
device=\gdt\gdtxdos.exe

device=\gdt\gdtaspi.exe /R:H1I4
device=aspidisk.sys

Note: Drives run with ASPIDISK.SYS are not compatible with drives run with GDTSETUP.

''

88VVLLQQJ

JFFRRUUHHOO66&&66,,

Step 1:

 Include GDTX0000.EXE, GDTASPI.EXE with appropriate reservations (../R:..) in the

CONFIG.SYS file, then do a warm reboot (Ctrl+Alt+Del).

Step 2:

 Load corel’s 

Install

 program and follow the instructions. Preferably, use 

Express-Setup

.

Step 3:

 After the successful installation, do a warm reboot (Ctrl+Alt+Del).

Step 4:

 Using the corelSCSI program CFORMAT, format the drive to be run through the ASPI

interface.

The CONFIG.SYS will be similar to the file below (the relevant entries are printed bold). The
parameters following the corelSCSI driver refer to a particular configuration, they have
automatically been added by the corelSCSI INSTALL program.

device=gdtx000.exe

files=30
buffers=30
stacks=9,256
shell=\COMMAND.COM /E:512 /P
device=\gdt\gdtxdos.exe

device=\gdt\gdtaspi.exe /R:H1I4
device=\coreldrv\UNI_ASP.SYS /C:4 /ID:4;;;1 /VOL:1 /DOS4 /SS:512 /@4:-98

Note: Drives run with corelSCSI and the UNI_ASP.SYS driver are neither compatible with
drives run with GDTSETUP and the GDT cache nor with those run with the above mentioned
ASPIDISK.SYS driver.

',QVWDOOLQJ:LQGRZV

To install Windows 95, a fully operational MS-DOS operating system is needed on the par-
tition on which Windows 95 is to be installed. Furthermore, you need a CD-ROM that is fully
accessible under MS-DOS and connected to the ICP Controller. For further details, please
refer to section D.6 of this chapter. The CONFIG.SYS file must at least include the entries for
GDTX000.EXE, GDTASPI.EXE and the ASPI module (e.g., ASPICD).

Step 1

Disable the 

Delayed Write

 Cache of the ICP Controller. To do so use the GDTSETUP pro-

gram, or the GDTMON program.