516 01 3604 04
Specifications subject to change without notice.
13
Fig. 15 — Damper Assembly
ECONOMIZER AND TWO-POSITION HOOD
ASSEMBLY
NOTE: If the power exhaust accessory is to be installed on
the unit, the hood shipped with the unit will not be used and
must be discarded. Save the aluminum filter for use in the
power exhaust hood assembly.
1. The indoor coil access panel will be used as the top
of the hood. Remove the screws along the sides and
bottom of the indoor coil access panel. See Fig. 16.
2. Swing out indoor coil access panel and insert the
hood sides under the panel (hood top). Be careful not
to lift the panel too far as it might fall out. Use the
screws provided to attach the hood sides to the hood
top. Use screws provided to attach the hood sides to
the unit. See Fig. 17.
3. Remove the shipping tape holding the economizer
barometric relief damper in place (economizer only).
4. Insert the hood divider between the hood sides. See
Fig. 17 and 18. Secure hood divider with 3 screws on
each hood side. The hood divider is also used as the
bottom filter rack for the aluminum filter.
5. Attach the post that separates the filters with the
screws provided.
6. Open the filter clips which are located underneath the
hood top. Insert the aluminum filter into the bottom fil
-
ter rack (hood divider). Push the filter into position
past the open filter clips. Close the filter clips to lock
the filter into place. See Fig. 18.
7. Install the two rain deflectors on the edge of the hood
top as shown in Fig. 17.
8. Caulk the ends of the joint between the unit top panel
and the hood top.
9. Replace the filter access panel.
Fig. 16 — Indoor Coil Access Panel Relocation
Fig. 17 — Economizer Hood Construction
Fig. 18 — Economizer Filter Installation
HOOD PARTS
PLASTIC TIE WRAP
QTY (2)
SCREWS FOR METAL TRAY
QTY (2)
TOP
PANEL
INDOOR
COIL
ACCESS
PANEL
INDOOR
COIL
ACCESS
PANEL
CAULK
HERE
TOP
PANEL
RAIN DEFLECTORS
TOP
PANEL
INDOOR COIL
ACCESS PANEL
SCREW
HOOD DIVIDER
LEFT
HOOD
SIDE
DIVIDER
BAROMETRIC
RELIEF
CLEANABLE
ALUMINUM
FILTER
FILTER
HOOD
FILTER
CLIP
OUTSIDE
AIR
