I.C.P. Srl
Savannah™ VG
- XL VG
AIRPLANE
MAINTENANCEMANUAL
01-12-51-122
Page 10
Issue 1/Revision 04
ICP Srl
– S.P.16 km 15,150-14022 Castelnuovo Don Bosco (AT)
August 2011
Phone +39-0119927503
•
Fax +39-0119927266
the hook is locked, the control cable for condition
15
Check the electric wires for condition, routing and security; check
the anti-collision lights control box for condition, if installed
16
Check the flaperon and elevator springs for security; adjust if
required
17
Visually inspect the fuselage interior; close the inspection panel at
the fuselage bottom
18
Check the landing gear for general condition; check the wheel
fairings if installed, the tires for wear and proper pressure
19
Check and, if required, adjust the brake control
20
Check the nose gear elastic chord and the sliding strut for excess
of play, clean and lubricate properly
21
Check the pedal rods and rod-ends; clean and lubricate properly
NB WARNING: following a hard landing, particularly if happened in
a crosswind situation, check the wheel fork alignment.
22
Check all the bolts, nuts and attachment connections of the wings:
all the safety locking devices should be in place and not broken
23
Check the flaperon hinges: they should be show freedom of
movement and no play and be fitted with the safety locks
24
Clean all the flaperon hinges and lubricate
25
Check all the empennages hinges for freedom of movement and
no play, clean and lubricate; Check the cable end attachment
fittings for condition, freedom of movement, no play, cleanliness
and lubrication
26
Inspect for condition and security the four (4) horizontal tailplane
to fuselage attachment connections
27
Check all the inspection panels for condition and security, their
hinges and fasteners; clean and lubricate properly
28
Inside the cabin check for general condition, open the control
stick repair, check all hinges, screws, nuts, safety locks, for
freedom of movement, excessive play
29
Lubricate the control stick mechanism (3 spots)
30
Close the control stick repair; make sure to fix it.
31
Visually inspect the cabin electrical system, the brake system’s
pipes and cables, the cabin switches, breakers, all controls
32
Lubricate the brake system cables and the rudder pedals
33
Clean all inside the cabin
NB
NOTE: to properly maintain the engine it’s strongly
recommended to follow the engine manufacturer instructions
and all Rotax service informations
34
Fuel system: visually inspect pipes, clamps, fuel filter, electric
pump and mechanical pump; clean and inspect float chambers and
