14
•
JP4: Watchdog Active Type Setting
JP4
DESCRIPTION
1-2
DISABLED WDT
2-3
RESET WHEN WDT TIME-OUT
2.5 Clear CMOS Setup
If you need to clear the CMOS Setup (For example, you have
forgotten the password. Then what you should do is to clear
setup and reset the password.), you should close the JP1 for
about 3 seconds then open it again. Opening JP1 can set
system back to normal operation mode.
•
JP1: Clear CMOS Setup (Reserve Function)
JP1 DESCRIPTION
1-2
Normal Operation
2-3
Clear CMOS Setup
2.6 LCD VCC Voltage /Panel Shift Clock
Selector
The LCD interface connector JP5 can provide 5V or 3.3V power
supply by selecting the JP5 to meet the different LCD
requirement.
The Panel Shift Clock Selector interface connector JP6 can
provide are sampled on the rising edge or falling edge by any
different LCD requirement.
Summary of Contents for WAFER-5823
Page 11: ...11 WAFER 5823 Board Jumper Setting...
Page 12: ...12 WAFER 5823 Board Dimensions...
