EtherCAT to Modbus RTU Gateway
Copyright © 2017 ICP DAS CO., Ltd. All Rights Reserved.
-
58 -
If the DC is set to 20 ms, the cycle time of
DIO_Addr01_1.txt
is given as follows:
One com command_02 = about 13.2ms.
If the DC cycle time is set to 10 ms < 13.2 ms, the ECAT-2610 will sync to DC at every first command.
So the timing diagram of DC=10 mS is as same as DC=20 ms above. The total command cycle time
can be greater then DC cycle time without any problem.
Sync to DC at every first command
Figure 7.1-9