36
7
GUI Operation
Connect the IPC to the monitor and then boot up the device. You can use the monitor to view the
analog video output, and use the remote control to realized network setup, encode setup and etc.
Note:
Please use the remote control to highlight the item, and then you can implement the setup.
7.1
Main Menu
Line up the remote control to the IR port in the rear panel. Click Enter button to go to the software
menu operation interface. See Figure 7-1.
Use the left/Right button in the remote control to select the item you desire and then click Enter
button to go to the sub-menu. Click ESC button to exit current interface.
Figure 7-1
7.2
Network Setup
Network setup interface is shown as below. See Figure 7-2 and Figure 7-3(For –W series only).
Please use the Left/Right button to select the item you want to set, use the number or Up/Down
key to set the value. For item of only one option, please move the cursor to highlight the
corresponding parameter and then click Enter button to save current modification.
Please follow the steps listed below.
z
Firstly, move the cursor to the port item and then select the corresponding network card
(Figure 7-2). For –W series product, ff you want to use the wireless network, you need to
enable port 02 and then highlight the “preferred” item (Figure 7-3).
z
Secondly, click the Right button in the remote control to move the cursor to DHCP item and
then click Enter button to enable DHCP function.
z
Thirdly, click the Right button to move the cursor to the IP address item, click Up/Down
button or click number button to set the value you desire. Click Right button you can go on
the next setup. Click Left button you can go to the previous setup. Click Enter button to save
current modification.
z
Finally, after you completed all setups, highlight the Save item and then click Enter button in
the remote control to save the latest modification. If you want to cancel current setup, please
highlight the Cancel button and then click the Enter button in the remote control or you can
just click the ESC button in the remote control directly.
You can set one item and then save it for security, or you can complete all setups and then save
all modifications at the same time.
