Installation Guide
Before you can install the product, you need to prepare your site:
DVI & USB
up to 100m CAT 5e/6/7
(STP recommended)
REX
LEX
Computer
Monitor
1.
Determine where the computer is to be located and set up the computer.
2.
Determine where you want to locate the remote desktop including the monitor, keyboard, mouse
and any other USB device(s).
3.
If you are using surface cabling, the product supports a maximum distance of 100m (330 ft).
or
If you are using premise cabling, ensure the
CAT
5e/6/7 cabling is installed between the two
locations,with
CAT
5e/6/7 information outlets located near both the computer and the USB device(s),
and the total length, including patch cords is no more than 100m.
Installing the LEX Unit
1.
Place the LEX unit near the computer.
2.
Install the supplied USB cable to the USB port on the LEX, and an available USB 2.0/1.1 Type A Port on
the computer.
3.
Install the
supplied HDMI cable to the LEX
(HDMI In), and an available HDMI Port on the computer.
4.
Plug the 5V, 3A power adapter into a suitable AC outlet near the LEX.
Installing the REX Unit
1.
Place the REX unit near the monitor and USB device(s) in the desired remote location.
2.
Connect the REX (HDMI Out) to the monitor with
a high quality HDMI cable
.
3.
Plug in your USB device(s) into the USB ports on the REX.
4.
Plug the 5V, 3A power adapter into a suitable AC outlet near the REX.
8
