Chapter 1: Pre-Configuration
Manual Number: 41209-003-2
Page 1-3
Jumper Types
Jumpers are small copper pins attached to the system board. Covering two pins with a shunt closes
the connection between them. The 586MBHP examines these jumpers to determine specific con-
figuration information. There are three different categories of jumpers on the 586MBHP.
A: Two pin jumpers are used for binary selections such as enable or disable. Instructions for this
type of jumper are open, for no shunt over the pins or closed, when the shunt covers the pins.
B: Three or four pin jumpers are used for multiple selection. Instructions for these jumpers will
indicate which two pins to cover. For example: for JPx2-3 the shunt will be covering pins 2
and 3 leaving pins 1 and 4 exposed.
C: Grouped Jumpers are used when a certain function has multiple selections. There are two
grouped jumpers on the board and careful attention should be given when setting these jumpers.
Instructions for grouped jumpers are similar to those above Jumper Location and Pin Numbers.
Jumper Locations
Use the diagram below and the tables on the following pages to locate and set the on-board con-
figuration jumpers.
Note:
Jumpers JP3 and JP4 are factory set and should not be changed.
-3
-3
-3
-3
-3
-3
-3
-3
-3
-3
-3-3
-3
-3
-3
-3
-3
Figure 1-2: Jumper Locations
Summary of Contents for 586MBHP Series
