2-6
2
2
Apply power to the 8099 and verify that it passes its selftest routine
and that the PWR, RDY and LAN LEDs are on.
3
Check your computer’s network settings to be sure its IP address is
in the 192.168.0.xxx range so it can communicate with the card’s de-
fault IP address. If it is not, it must be set before proceeding. Use the
values shown below. For Windows PCs, right-click on My Network
Places and click on Properties. Right-click on Local Area Connection
and click Properties. Highlight Internet Protocol (TCP/IP) and click
Properties. If your PC’s IP address is in a different range, record the
current settings and temporarily set the following network values:
Check
‘Use the following IP Address’
IP Address
192.168.0.2
Subnet mask
255.255.255.0
4.
Open the browser and enter the default IP address of 192.168.0.254
for new units (or your last set address for older units) in the browser
address window. A Welcome Page similar to the one shown Figure
2-5 should appear in your browser.
5.
If you want to change any of the settings, press the ‘Update Configura-
tion’ button. A Configuration Page similar to the one shown in Figure
2-6 should appear in your browser.
Figure 2-5 8099 Welcome Page
