Auto Passport Installation Guide
Page 10
Copyright © Innovative Control Systems, Inc.
7'
–
1
1 5
/8
"
RFID
ANTENNA
ENCLOSURE
CL
CENTER LINE OF
RFID UNIT
4' – 7"
2' – 6"
5
3/8"
TRAFFIC LANE
GRADE
0' - 6"
3' – 6 1/2"
7' –11
"
8' –5
"
RFID LANE – SIDE VIEW
THIS DRAWING IS NOT TO SCALE
CONCRETE ISLAND
6' – 7"
8'
–
8"
9'
–2"
NOTE:
CONCRETE ISLAND MUST BE 6 INCHES
ABOVE THE FINAL TRAFFIC LANE GRADE
Figure 11. RFID Reader/Antenna Enclosure on Truss
Figure 12. RFID Enclosure Mounting on Truss
RFID All-In-One Reader/Antenna Mounting
1. Attach the RFID All-In-One Reader / Antenna enclosure to the truss that is next the Auto Sentry and extends over the lane.
The truss will be shipped with truss brackets and hex screws. (1/8”
Allen key is needed to install but not supplied by ICS).
2. Mount the center of the enclosure at 3’ 6-1/2” from the edge of the curb.
To ensure the proper angle for the antenna, the enclosure should be
mounted so the top of the enclosure is level. The antenna is angled
inside of the enclosure. The enclosure will appear to be facing down.
See Figure 9, Figure 11, and Figure 12.
3. Route cable down through the center of the truss. ICS recommends
securing the cable to the truss every 12 inches with cable ties.
4. Use diagonal cutters to cut excess length off of the cable ties.
IMPNROAOE:
The enclosure should not be rotated on the truss as that would
move the antenna to a position where it is not designed to work properly.
