2-4
Hardware Settings
CPU Jumper Settings
Note:
There is no hardware jumper for CPU core/bus ratio. This
configuration is handled through the BIOS.
(Hardware Monitoring Setup Menu)
Note:
To enable the Watchdog Timer (WDT), and have WDT ready for
trigger, cover the jumper cap for JP16 then configure the
“Watchdog
Timer
Controller
”
option in BIOS Advanced Chipset Setup to determine
when the first WDT trigger should be activated. Please refer to Chapter 3
for details.
Note:
The FWH (Firmware Hub) Write Protection option jumper
enables/disables the BIOS chip as a flashable ROM.
Note:
Refer to Chapter 3 for correct clear CMOS operation.
Note:
Enabling JP6 will force the system to run with x2 core/bus ratio.
Note:
Enabling JP8 will produce a SCSI termination onboard.
