3-12
System Installation
Clear CMOS Operation
The following table will show you how to enable and disable the CMOS Clear Function
hardware circuit using JP1.
To correctly operate the Clear CMOS function, apply a jumper over JP1. This will not consume
any power. Then configure the (Advanced Chipset Setup) CMOS RAM Clear Function in the
BIOS to
Enabled
. Reboot the system to produce a “CMOS Check Sum Error” message and
hold up the system. You may then follow the displayed message to load the BIOS default
setting.
JP1
FUNCTION
NA
Normal Operation
Short
Clear CMOS
