Power Switch Setup 3-13
Sy
st
em Inst
allat
io
n
Power Switch Setup
Momentary Power Switch Setup
*
To configure the single board computer to accommodate Omnix chassis with a
momentary on/off switch, follow these steps:
1)
Select jumper pins 3-5 and 4-6 on JP3, AT/ATX Power Select (Figure 3-1).
2)
Connect JP2, ATX Power Button Interface, to the momentary power switch
on the chassis.
3)
Route ATX signals from the power supply to J11, ATX Power Control
Connector.
Figure 3-1. JP3, AT/ATX Power Select, Jumper Pins
* See “Wiring Diagrams” in your chassis user’s guide.
JP3
2
4
6
Select Jumper Pins 3-5 and 4-6
1
3
5
