Page 26
Setup Mode, NAVTEX View, 518 and 490 Names Pages
The station names setup pages determine the
names of stations displayed on station filter pages
and in NAVTEX message headers.
The picture shows the ‘518 Names’ page; the ‘490
Names’ page is similar.
Use the UP and DOWN keys to select the setting
that you wish to edit. Use the LEFT and RIGHT
keys to change the setting.
The Station Name Selection setting allows the user
to select between ‘GPS’ and ‘Manual’ station
selection. If ‘GPS’ is selected the ICS NAV6 will
select the NAVTEX transmitting station name
nearest to the boat’s current location, but within the
same NAV area.
If ‘Manual’ is selected, then the user can manually
select the transmitting station name to be displayed
for each station letter.
(Tip : You may be sailing in Nav Area II and therefore will pick station names from
Nav Area II. However it is important to realise that the corresponding station letter
in the adjacent Nav Areas may be closer. For example, the ‘S’ station that you are
receiving is the ‘S’ station in an adjacent Nav Area).
Setup Mode, NAVTEX View, 518 and 490 Names, Station
Database Setup
Press the STATION DATABASE softkey from
within the [Setup Mode
⇒
NAVTEX View
⇒
518 or
490 Names Page] to display the station database
setup page for 518 or 490 kHz.
Press the EXIT softkey to leave the station
database setup.
The station database page is divided into two
halves. The top half shows a scrolling list of all
stations in the database. The bottom half shows
details of the current station selected in the station
list.
Summary of Contents for Nav6
