Manual Number: 40110-005-2
Page 49
Available options are:
Not Installed
360
KB 5-1/4
1.2
MB 5-1/4
720
KB 3-1/2
1.44
MB 3-1/2
2.88
MB 3-1/2
The Not Installed option can be used for diskless work stations.
Primary and Secondary Hard Disk Drives
The processor board supports up to four hard disk drives through a primary and secondary control-
ler in a master/slave configuration. The primary controller uses I/O port addresses 1F0H through
1F7H, 3F6H and IRQ14. The secondary controller uses I/O port addresses 170H through 177H,
376H and IRQ15.
The AMIBIOS enhanced IDE (EIDE) interface can support IDE Type4 disk drives. This EIDE
interface allows disk drives greater than 528MB to be used.
The hard disk drives can be detected automatically by AMIBIOS (if they are IDE drives) or can be
defined manually by the user, as described below.
The Setup screen displays the system options:
Pri Master:
Auto
Pri Slave:
Auto
Sec Master:
Auto
Sec Slave:
Auto
The Help window displays:
1-46:
Predefined types
USER:
Enter parameters manually
AUTO:
Set parameters automatically on each boot
CD-ROM: Use for ATAPI CD-ROM drives Or press ENTER to set all DD parameters
automatically
To set up the hard disk drive parameter(s), use the plus (+) key or PgDn key to scroll through the
drive types to locate the correct type of disk drive(s) in your computer.
Summary of Contents for SB686P Series
