71
«
Motor Error
：
A
»
Code: E21
LED Light Display: None
LCM Display: As shown in figure below
Cause: The first motor group cannot be positioned. The first motor group might be
damaged, coin or foreign objects might have caused the motor to stuck, coins are stuck
in the coin tube, or the semicircle disk has derailed.
Corrective Measure: 1. Confirm whether a foreign object has caused the semicircle disk
to get stuck. If yes, remove the object and turn on the power
again. Use buttons
A
and
B
of the LCM to test and determine
whether the semicircle disk can be returned to its normal
position. If it does, then the machine has returned to its normal
operation.
2. Verify whether the semicircle disk has derailed. If yes, turn off
the power and remove the washer, then reinstall the
disk back
onto the track and reactive the machine. Use buttons
A
and
B
of
the LCM to test and determine whether the semicircle disk can
be returned to its normal position. If it does, then the machine
has returned to normal operation.
Left Coin Jam
E21
Summary of Contents for cc6000
