ICT EliteSuite ELT-KLES, User Manual

ELT-KLES 

EliteSuite Eclipse LED Keypad 

User Manual | February 2014 

13

User Setup Menu 

To Enter the Setup Menu: 



Press the [MENU] key then enter your [USER CODE]. 

The ARMED status LED will begin to flash once you have successfully logged in, informing you that you are 
in programming mode. 

To Exit the Setup Menu 



To exit programming mode, press the [CLEAR] key until the ARMED status LED stops flashing. 

Alternatively, if do not press any key for 20 seconds you will be automatically logged out. 

Viewing, Editing, and Deleting User Codes 

Your EliteSuite system uses four digit user codes, where each digit can be any value from 0 to 9. Avoid 
programming simple or obvious user codes, such as part of your telephone number or address and codes such 
as 1234, 1111 or 1212. 

To view an existing code 



From the User Setup menu, press [MENU], 5, [USER NUMBER], , 1, 



If the user has a valid code it will be displayed as a sequence of four number LEDs lighting one after the 
other. If the User code is blank then no code will be displayed when you press the ENTER key (

) and the 

rejection tone will sound. 

To program a new code, or modify an existing code 



From the User Setup menu, press [MENU], 5, [USER NUMBER], [ENTER], 1, [USER CODE], [ENTER] 

The keypad will beep twice and the ARMED status LED will flash quickly 



Confirm the user code by pressing [USER CODE], [ENTER] 



If correct, the confirmation tone will sound and the ARMED LED will return to a slow flash. 



If incorrect, a rejection tone will sound and the confirmation process must be repeated. 

To delete a user code: 



From the User Setup menu, press [MENU], [5], [USER NUMBER], [ENTER], 1, [FNC], 2, [ENTER], [FNC], 2, 
[ENTER] 



The keypad will beep four times to confirm that the code has been deleted.