DEVICE SETUP
This page allows you to configure the device settings of the panel. To save any changes to the device
settings, click on
Save Settings
at the bottom of this page.
DEVICE INFO
Site Name:
Allows you to assign a custom name to the panel.
Model:
Displays the model number of the panel.
Hardware:
Displays the hardware version of the panel.
DATE AND TIME SETTINGS
Current System Time:
Displays the current date and time of the panel’s onboard clock. This clock is
used to timestamp the log entries in the data log. The clock can either be set manually, or it can be
synchronized with a remote NTP Time Server over Ethernet.
Synchronizing the clock with a NTP Server is recommended to ensure that the date and time will still be
correct after a power failure.
Synchronize with NTP Server:
Checking this box will enable date and time synchronization with a NTP
Server. A valid server address must also be entered in the NTP Server field.
NTP Server:
The name or IP address of the NTP Server used for date and time synchronization
(such as pool.ntp.org ).
Time Zone:
Select a time zone to convert the time received from the NTP Server to your local time.
Set Time Manually:
Checking this box will allow you to manually set the panel’s date and time. The
date must be entered in MM/DD/YY format, and the time must be entered in HH:MM:SS format.
POWER-ON SEQUENCING / CYCLING
Sequence / Cycle Delay:
Entering a time delay in this field will cause all outputs to be enabled in
sequence when the
Enable All Outputs
button is pressed on the
Status & Control
page, rather than
enabling all outputs simultaneously. This delay helps prevent power surges that can occur when too
many devices are turned on at the same time. The time delay before each output is enabled can be set
to a value between 0 and 60 seconds.
If the
Power Cycling
option is enabled for any outputs on the
Output Setup
page, this field also sets
the Power Cycle time delay.
11
Summary of Contents for ICT180S-12IRC
Page 2: ......
