ICT ICT180S-12IRC, Instruction Manual

OUTPUT SETUP

This page allows you to configure the output settings of the panel. In the 

Select an Output

 to edit box, 

click on the output number of the output you wish to configure. To save any changes to the output 
settings, click on 

Save Settings

 at the bottom of this page.

To copy the configuration settings from one output to all of the other outputs, click on 

Copy Settings to 

All

, and then click on 

Save Settings

 to save the new settings.

OUTPUT SETTINGS

Label:

 Allows you to assign a custom name to each individual output. The output names are displayed 

on the 

Status & Control

 page, as well as on the LCD screen.

Output State after Panel Reset: 

Allows you set the output state of the selected output after a power 

failure or a soft reset. Select one of the following options:

  - “Restore Last State”: If this option is selected, the panel will remember if this output was enabled or
      disabled prior to the power failure or reset. The output will restored to the same state after the panel
      starts up.

  - “Enable Output”: If this option is selected, this output will always be enabled after the panel starts
       up after a power failure or reset.

  - “Disable Output”: If this option is selected, this output will always be disabled after the panel starts
       up after a power failure or reset.

Ignore Fuse Status: 

If this box is checked, the panel will not monitor the status of the fuse for the 

selected output. This will prevent nuisance alarms if an unused output does not have a fuse in place.

Enable Power Cycling: 

Checking this box will turn on power-cycling for the selected output. When 

Power-Cycling is enabled for an output, the output will automatically be re-enabled after a selectable 
period of time after it is disabled from the 

Status & Control

 page. Power-Cycling is useful for remotely 

resetting power to hardware that is needed for network connectivity to the panel.

If Power Cycling is enabled for any outputs, the 

Sequence/Cycle Delay

 setting must be also set on the 

Device Setup

 page.

If multiple outputs with Power-Cycling enabled are disabled from the 

Status & Control 

page at the 

same time, they will be re-enabled in sequence.

13