ICT ICT180S-12IRC, Instruction Manual

NETWORK SETUP

WARNING:

 Changing the network settings will reboot the panel..

This page allows you to configure the network settings of the panel.  To save any changes to the network 
settings, click on 

Save Settings

 at the bottom of this page and panel will reboot.

NETWORK

MAC Address:

 Displays the MAC address assigned to the panel.  It can also be found on line 4 of the 

network status screen of the LCD (see 

LCD/Select Button Operation

).

Enable DHCP:

 Turn on this setting if your network is using a DHCP server to automatically assign IP 

addresses (DHCP is enabled by default).  To manually assign a Static IP address to the panel, uncheck 
the 

Enable DHCP

 box and then set the following settings.

IP Address: 

Specify a unique IP address for the panel.

Subnet Mask: 

Specify the mask for the subnet the panel is located on.

Gateway:

 Specify the IP address of the default router (gateway) used for connecting attached devices to 

different networks.

Primary DNS:

 Specify the IP address of the Primary DNS Server for your network.

Secondary DNS:

 Specify the IP address of the Secondary DNS Server for your network.

WEB SERVER

WARNING:

 Changing these ports may affect your ability to access the panel.

The web server port numbers can be changed to any port within the range 1 – 65565.

HTTP Port:

 Allows you to change the HTTP port number.  This port is used for HTTP traffic between the 

panel and web browser.  The default HTTP port is 

80

.  If you change the HTTP port to a number besides 

80, you will have to append the new port number to the URL used to access the panel (e.g. 

http://192.168.0.180:8000

 for IP address 

192.168.0.180

, port 

8000

).

HTTPS Port:

 Allows you to change the HTTPS port number used by the panel.  HTTPS (HTTP secure) is a 

protocol which encrypts data transfered between web browsers and servers.  The default HTTPS port is 

443

. 

To access the panel through a secure HTTPS connection, type 

https://

 in front of the URL used to access 

the panel (e.g. 

https://192.168.0.180:8888

 for IP address 

192.168.0.180

, HTTPS port 

8888

).

UDP Port: 

Allows you to change the UDP port number used by the panel. This port is used when applying 

firmware upgrades to the panel. The default UDP port is 

9393

.

16