ICT ICT180S-12IRC, Instruction Manual

ALARM SETUP

This page allows you to select which alarms you wish to monitor, and also allows you to enter custom 
thresholds for each status condition.  To save any changes to the alarm settings, click on 

Save Settings

at the bottom of this page.

FUSE ALARM

Activate Alarm Form C Contact:

 If this box is checked, the alarm form “C” contacts on the panel will 

indicate a fault condition when an output fuse is blown.

Send E-mail: 

If this box is checked, an e-mail alarm notification will be sent when an output fuse is 

blown.  The e-mail settings on the 

E-mail Setup

 page must be configured correctly before e-mail 

notifications can be sent.

SYSTEM UNDER-VOLTAGE ALARM

Under-Voltage Threshold:

 If the system voltage drops below the value in this field, the system under-

voltage alarm will trigger.

Under-Voltage Recovery:

 If the system voltage rises above the value in this field, the system under-

voltage alarm will clear. The value in this field must be at least 0.50V higher then the Under-Voltage 
Threshold.

Activate Alarm Form C Contact: 

If this box is checked, the Alarm Form “C” Contacts on the panel will 

indicate a fault condition when the system under-voltage alarm is triggered.

Send E-mail:

 If this box is checked, an e-mail alarm notification will be sent when the system under-

voltage alarm is triggered.  The e-mail settings on the

 E-mail Setup

 page must be configured correctly 

before e-mail notifications can be sent.

SYSTEM OVER-VOLTAGE ALARM

Over-Voltage Threshold:

 If the system voltage rises above the value in this field, the system over-

voltage alarm will trigger.

Activate Alarm Form C Contact: 

If this box is checked, the alarm form “C” contacts on the panel will 

indicate a fault condition when the system over-voltage alarm is triggered.

Send E-mail:

 If this box is checked, an e-mail alarm notification will be sent when the system over-

voltage alarm is triggered.  The e-mail settings on the 

E-mail Setup

 page must be configured correctly 

before e-mail notifications can be sent.

19