ICT ICT180S-12IRC, Instruction Manual

PASSWORD RESET

Resetting the password resets the Administrator password, network and web server settings to the 
original factory default values. The Standard User password is not affected. To reset, do the following:

1.  Press and hold the 

Output Select

 button on the front of the panel (approximately 20 seconds) until 

Resetting

 is shown on the LCD.

2.  Release the button.

3.  After reset is complete, press and release the 

Output Select

 button once to view the network status 

screen on the LCD.  The new IP address of the panel will be displayed.

ROUTER CONFIGURATION

This section explains how to set up the panel behind a router and enable remote access to the panel 
over the Internet.

A router allows multiple PCs to share a single Internet connection.  To enable access to the panel over 
the Internet, you will need to configure your router to forward incoming remote data to the local IP 
address of your panel.

The following steps use a Linksys WRT54G router as an example.

1.  Log in to your router and go to the port forwarding screen.  In the Linksys WRT54G, this is located in 
the 

Applications and Gaming

 tab.  The location of port forwarding may be different on other routers 

(consult your router manual for instructions).

2.  To configure HTTP forwarding, following these steps:

a.  Enter a unique name in the 

Application 

field.

b.  Enter the HTTP port number that the panel is using in the 

Start

 and 

End

 fields.  If you are

     using the default panel port settings, the port number is 

80

.  

c.  Select 

Both

 under

 Protocol 

(TCP and UDP).

d.  Enter the local IP address of the panel (e.g. 192.168.0.180) in the 

IP Address

 field.  See

     step 2 of 

Web-based Configuration Utility

 section to find the actual local IP address of   

     your panel. 

 e. 

Check 

Enable

, and then click on 

Save Settings

.

NOTE:  

Many ISPs block access to port 80.  If your ISP does block port 80, you will need to change

the HTTP port the panel uses from 80 to something else, such as 8000. Valid port numbers

are in the range of 1 - 65535. See the 

Network Setup

 section for instructions on how to

change the panel network ports. You will also need to change the HTTP port number from

80 to something else if your local network already contains another device using port 80

such as another panel or a web server.

24