Innovative Circuit Technology Ltd.
17
Bus Setup
Use this page to configure each bus. Select Bus A, or Bus B in the
Select a Bus to
Edit
box to call up the settings for that bus. Click on the
Save Settings
button at
the bottom of the page to save any changes you make.
Bus A/B Settings:
Bus Name:
Enter a descriptive name for the selected bus if desired
Bus A/B Under Voltage Alarm:
Under-Voltage Threshold:
Enter the bus under voltage value. Bus voltage
dropping below this level will trigger a Bus Under-Voltage alarm.
Under-Voltage Recovery:
Enter the bus voltage required to reset the alarm.
Bus voltage rising above this level will clear the alarm.
Activate Form-C Contact
: Checking this box will cause the Alarm relay to
trigger for an under voltage condition. (default)
Send E-mail
: Checking this box will cause the unit to send a Bus Under-
Voltage alarm e-mail to the assigned address entered on the
E-mail Setup
page.
Bus A/B Over Voltage Alarm:
Over-Voltage Threshold:
Enter the bus over-voltage value. Bus voltage rising
above this level will trigger a Bus Over Voltage alarm.
Activate Form-C Contact
: Checking this box will cause the Alarm relay to
trigger for an over voltage condition. (default)
Send E-mail
: Checking this box will cause the unit to send a Bus Over-Voltage
alarm e-mail to the assigned address entered on the
E-mail Setup
page.
Bus A/B Over-Current Alarm:
Over-Current Threshold
: Enter the maximum total current level for the bus.
Current exceeding this level will trigger the Over-Current alarm.
Activate Form-C Contact
: Checking this box will cause the Alarm relay to
trigger for an over-current condition. (default)
Send E-mail
: Checking this box will cause the unit to send a Bus Over-Current
alarm e-mail to the assigned address entered on the
E-mail Setup
page
