22
Innovative Circuit Technology Ltd.
SMTP Server
: Enter the name or the IP address of your SMTP server used for
sending outgoing e-mail. (e.g. “smtp.gmail.com”)
SMTP Port
: Enter the port used by your SMTP server. (Normally 25)
SMTP Server requires SSL
: Check this box if your SMTP server requires an
encrypted SSL connection.
Sender E-mail Address
: Enter an e-mail address that will appear as the
sender for all e-mail notifications sent from the panel.
Recipient E-mail Addresses
: Enter one or more e-mail addresses that are to
receive all e-mail notifications from the panel. Use commas to separate
multiple addresses. This field can also be used to send a text message
notification to a phone; see the
Text Message Alarm Notifications
section
for further information.
SMTP User Name
: Enter a SMTP user name here, if required by your SMTP
server. Leave this field blank if the server does not require authentication.
SMTP Password
: Enter a SMTP password here, if required by your SMTP
server. Leave this field blank if the server does not require authentication.
Minimum E-mail Interval
: Specify a minimum interval required between e-
mail notifications. (Default 1 minute, range 0 to 60 minutes) This time
interval is used to prevent an un-intended flood of e-mail alarm notifications
that could occur when an alarm limit is incorrectly configured, for example.
General E-mail Notifications
:
Select these options to receive an e-mail when one or more of these events
occurs.
The Distribution Panel restarts
: Check this box to receive an e-mail
notification when the panel restarts after a power failure or a soft reset.
Load-Shedding is activated
: Check this box to receive an e-mail notification
when any of the outputs are disabled or enabled due the voltage crossing
one of the load-shed settings configured on the
Output Setup
page.
The Network Watchdog triggers
: Check this box to receive an e-mail
notification after the Network Watchdog triggers due to a loss of the
network connection and the network has comes back online.
