Innovative Circuit Technology Ltd.
23
Alarm setup
Use this page to configure the set points of alarms to be monitored, and set the
required actions when an alarm is triggered. Click on the
Save Settings
button at
the bottom of the page to save any changes.
Circuit Breaker (Fuse) Alarm:
Activate Alarm Form-C Contact
: Check this box to have the bus A alarm
output trigger for any breaker or fuse on channel 1A to 6A opening, and
have the bus B alarm output trigger for any breaker or fuse on channel 1B to
6B opening.
Send E-mail
: Check this box to cause an e-mail notification to be sent when a
breaker or fuse opens on any of the output channels, stating which channel
is affected. Note that the e-mail settings must be fully configured on the
E-
mail Setup
page for this to occur.
Alarm Input #1 to #5:
Configure the five Site Monitor inputs to enable the panel
to monitor external contact closure events on door and window sensors, smoke
alarms, etc.
Alarm Name
: Enter a descriptive name for the external contact being
monitored. This will be used in e-mail and front panel alarm messages.
Contact Type
: Select if the external alarm contact input is to be used, and
what contact type is connected to each input. Choose “Normally Open”
contact, “Normally Closed” contact, or “Not Used”.
Activate Alarm Form-C Contact
: Check this box to have both bus alarm relay
outputs indicate a fault for an alarm condition on that input.
Send E-mail
: Check this box to have an email notification sent when one of
the enabled alarm inputs is triggered, stating which input was affected. Note
that the e-mail settings must be fully configured on the
E-mail Setup
page
for this to occur.
User Setup
Use this page to configure passwords for limiting access to the panel settings.
Click on the
Save Settings
button at the bottom of the page to save any
password changes.
The unit has no password assigned by default, so an Administrator password
should be assigned to your panel for improved security.
NOTE:
