ELECTRIC BICYCLE METER KT
—
LCD7C Product User Manual
- 17 -
P3 parameter setting interface
P3 is power assist control mode setting, when P3 parameter setting is1, power assist
control mode is gear 5 of "
imitation torque control
" mode, when P3 parameter setting is
0, power assist control mode is gear 5 of "
speed control
" mode. P3 parameter needs to be
determined according to the distributed function of the controller, its setting range is 0 or 1,
press
button
(UP)
or
button
(DOWN)
for selection.
○
P4 Handlebar Startup Setting
Enter P4 parameter setting interface, P4 parameter column flashes.
P4 parameter setting interface
P4 is handlebar startup setting, when P4 setting is 1, indicating the handlebar is under
"
non-zero startup
" mode, namely, the handlebar can be effective only after startup the
foot power assist. When P4 setting is 0, indicating the handlebar is under "
zero startup
"
mode, the motor can be startup by the handlebar directly. P4 setting range is 0 or 1, press
button (
UP
) or
button
(DOWN)
for selection.
○
P5 Power Monitoring Setting
Enter P5 parameter setting interface, P5 parameter column flashes.
