ELECTRIC BICYCLE METER KT
—
LCD7C Product User Manual
- 33 -
When L2=0, P1 parameter is set as the calculated value.
When L2=1, P1 parameter is set as a half of the calculated value.
After finishing L2 parameter setting, press
button (
SW
) to save the current
value and then enter L3 parameter setting interface.
○
L3 Parameter setting
L3 parameter is applicable to the dual mode controller. The default of the factory
is 1.
When L3=0, the controller will activate Non-Hall model only when the Hall
sensor in the motor fails
When L3=1, the controller will choose the proper model to use according to
the controller system optimization.
After finishing L3 parameter setting, press
button
(SW)
to return to parameter
setting interface.
○
L4 parameter setting
Under parameter setting interface, move cursor to L4 and press
button shortly
(SW)
, the value
flashes
L4 parameter is used to adjust the delay time of automatic shutdown of the LCD, the
default value is 5, and the range of adjust is 5-120 minutes.
