- 4 -
FLASHES
STATUS
1
bill jammed
2
disabled
from system
3
sensor
problem
4
reserved
5
bill
box is removed
6
LED
ON
POWER
ON
LED
OFF
POWER
OFF
bill box is full of money
The two LED lights located at the front of the unit will show the operational
status of the bill validator. The LED lights will flash ON and OFF (in 500ms
intervals) when the unit is ready to accept bills. The LED lights will be OFF
if the unit is disabled or out of service, in which case the unit will not accept
any bills.
The bill validator can only accept one bill at a time. The LED lights will be
OFF and will not accept another bill while a bill is being validated in the unit.
The LED lights will start to flash normally when the bill validator is ready to
accept the next bill.
(3) LED Display
(4) LED Status
(5) Download and Upgrade
In addition to the 30-pin connector, there is also an 8-pin RJ-45 connector
on the side of the bill validator designed for the purpose of downloading
programs and updating validation software. The connector will be kept open
under normal operation of the bill validator. It will only be used when a new
software or program need to be downloaded into the flash ROM. (Figure 1)
LED
Option Switches
COM2
C
O
M
2
PH
P
H
BACK LED
Figure 1
FP-001
FP-001
5
4
3
2
1
5
4
3
2
1
9
8
7
6
9
8
7
6
5
4 3 2 1
9 8 7 6
Option Switches
Summary of Contents for N7 Series
Page 6: ...8...
