5.
Hold the rear case of the card reader against the surface mount box in the correct orientation. Line up the
holes on the rear case with the threaded inserts
closest to the center
of the surface mount box, as shown in the
image below.
6.
Affix the rear case to the surface mount box using the two M4 x 10mm screws provided.
7.
Connect the wiring to the reader electronics through the conduit hole. Refer to later sections of this manual for
the wiring connections.
8.
Clip the upper rim of the front case over the upper rim of the rear case, then press gently on the front case until
the lower rim slots over the lower rim of the rear case, lining up the screw hole at the bottom.
9.
To complete the installation, use the M3 x 8mm Plastite screw provided with the card reader to secure and
fasten the front case to the rear mounted case.
TSL Multi-Technology Card Reader | Installation Manual
19
