9
ENGLISH
EN
4. Commissioning the charging station
the wall into the housing
3.
Attach the power cord into the gland by tighte
-
ning them so that the power cord can‘t be re
-
moved
4. Remove the power cord insulation using a wire
stripper so that the bare wires can be connec
-
ted in the isolator switch (
14
on the left of the
cover)
5.
Attach the wires to the right place in the residual
current circuit breaker (optional)
Always attach proper earth conductor first!
!
CAUTION!
6.
Turn off the power and then press the power
button
7. Connect all the leads of the LED connector on
the back
8. Lower the front cover with the two screwcams
into the slots on top of the rear cover
9. Tighten the two screws on top of the base unit
firmly with a Torx M5 screwdriver
10. Now close the front cover by pressing and at
-
taching the anti-theft screws M8 x 16 into the
holes on the back
11.
Finally remove the transparent film from the
front cover
4.1 Safety instructions before operating
Follow the below safety instructions before putting
your charger into operation:
1. Make sure that the charging station is securely
connected to the house supply line as specified
in this manual
2. Make sure that the supply line in the house dis-
tribution is separately protected by an appropri-
ate circuit breaker (B-characteristic)
3.
Make sure that the built-in charger or external
upstream RCD is switched on
4.
Make sure that the charging station has been
installed in accordance with this guidance
5.
Make sure that the housing is always locked in
normal operation
6.
Make sure that the charging cable is not twisted
and make sure that cable, charging plug and
housing are free of damage
4.2 Putting into operation
1.
Turn on the power at the power supply cable
The charger now performs a self test. The following
actions are performed by the charging station:
1.
The door lock is activated
2. The red LED lights up for one second conti-
nuously
3. All LEDs light up for one second continuously
4. The red LED flashes five times, so that the elec
-
tronics are started
5. All LEDs go out
6.
The ICU Eve is now ready for charging
Commissioning the charging station
