Nylock
Steel
race
3
Locate the 3/8 bolt assembly in the hardware
bag.
4
Remove wrapping from bearing and place the
end of the Elite arm on the wall mount.
5
Pass the 3/8 bolt with the bearing assembly
through the wall mount and the arm from under-
neath. Place the steel race over the bolt inside the arm
as shown and secure firmly with the nylock using the
provided 9/16 wrench and 5 mil hex key.
Note: Keep the
arm folded while
installing.
Elite arm mounted on wall
.
6
Extend the arm straight out and lay all of the
cables for your monitor, keyboard, and mouse in
the channel on top of the arm.
Be sure your cables are to
one or the other side of the
center adjustment hub.
Hub
Cable
NOTE: YOU MUST
LEAVE SOME SLACK
IN THE CORDS TO
ALLOW FOR ARM
MOVEMENT.
