If you have any questions, please call 1-800-558-4435
ERGOVISION 65 INSTRUCTIONS
ERGOVISION 65 INSTRUCTIONS - rev 04/22/14 pjm
Page 1 of 2
ATTACH WALL PLATE TO WALL
Locate the stud and mark
the top hole, drill 11/64
pilot hole and insert #14
screw and tighten slightly.
Using a level, mark the
lower hole and drill pilot
hole, insert #14 screw and,
with the unit level, tighten
both screws.
NOTE: ICW supplies #14
wood screws. If installing
onto metal studs, you will
need to replace with proper
metal stud fasteners.
Locate the wall stud and mark the top
hole of the Wall Track, drill 11/64 pilot
hole and insert #14 screw and tighten
slightly. Use a level, mark the lower
holes, drill pilot holes and then insert the
#14 screws.
NOTE: #14 Wood screws are supplied with unit. If
installing into metal studs, you will need to replace
these with proper metal stud fasteners
MOUNT ULTRA TRACK TO WALL
Remove
small socket
head cap
screw in the
top middle
of the Wall
Track.
Remove
plastic cover.
Insert Slider
into Wall Track
as shown
at left and
replace the
small socket
head cap
screw and
plastic cover.
ATTACH SLIDER TO ULTRA TRACK
Once you have adjusted the
slider to the desired height,
tighten down the Track
Slider using the handle on
the slider as shown.
Once tight, make sure the
handle is positioned so that
it is pointing down as far
as possible. Pull and turn
handle to position.
ATTACH POLE CLAMP TO POLE
Using the 1/4” hex key,
separate the two halves of
pole mount as shown, place
around pole at the desired
height and reassemble.
IF MOUNTING TO A POLE
IF MOUNTING TO THE
ULTRA WALL TRACK
IF MOUNTING TO A WALL
