Screw in the VESA interface plate into
the VESA hole pattern on the back of your
LCD monitor using the four 4mm phillips
screws provided.
Slide the rails into the EV65 joint.
(2) VESA plates
(1 ) Wall plate w/ track
(2) EV65 track sliders
(2) 1 4x2 1 /2"
wood screws
(2) 1 0-32x1 /4 sockethead
cap screws
(4) 4mm phillips screws
(2) 5/1 6-1 8x3/4L sockethead
cap screws
(1 ) 1 /4" hex key
(1 ) 5/32" hex key
Dual monitor EV65 wall mount
Bolt the rails into place using the two
5/1 6-1 8x3/4L sockethead cap screws
provided with the 1 /4" hex key provided.
Installation instructions for the EV65 dual monitor wall/track mount page 1
II001 10/19/2009 MF
Page 1
