After locating a wall stud and by using a
level, mark the holes for the wall place.
Create guide holes before screwing in the
countersunk 1 4x2 1 /2 wood screws
provided.
After loosening the slider plate on the
EV65, slide on to the track like shown in
the illustration. Once on, tighted the slider
place by using the indexing chrome
handle on the slider. Do this with both
monitors.
Once you have both monitors on the
track, locate the track endcaps in your
hardware bag. These will fit into each end
of the track, covering the sharp edges.
Using the two 1 0-32x1 /4 sockethead cap
screws provided, fasten the track endcaps
to the track like shown with the 5/32" hex
key.
Dual monitor EV65 wall mount
Page 2
Installation instructions for the EV65 dual monitor wall/track mount page 2
II001 10/19/2009 MF
