ICWUSA.com, Inc.
If you have any questions, please call 1-800-558-4435
LAPTOP TRAY ARM INSTALLATION
LAPTOP TRAY ARM INSTALLATION - rev 09/27/2011 mf
ULTRA WIRE
MANAGEMENT
[1] Prepare all
cables to route
within the arm by
placing them
near cavity of arm
and bundling together if necessary. Remove
cover by unscrewing two socket head cap
screws. Screws are captured by the cover
so they cannot fall out. Once screws are
disengaged, pull cover out of arm.
1
2
3
[2] Place cables over
cover and within the
channels. Do not block
the hole where screws
will engage in arm.
[3] Replace cover and
tighten screws. Cables
should be able to pull
through to desired
position if necessary.
ATTACH FLIPUP TO ARM
Attach the tray fl ip-up assembly to
the arm bracket using the provided
fl at head screws and hex key.
