MD ARM INSTALLATION INSTRUCTIONS
MD ARM INSTALLATION - 12/3/19
Page 1 of 2
MAXIMUM LOAD CAPACITY:
35 LBS (15.9 KG)
If Mounting Directly To Wall
ATTACH WALL PLATE TO WALL
Locate a stud in the wall
where the arm will be
mounted. Mark the top hole
and drill a 11/64 pilot hole.
Insert a provided #14 screw
and tighten slightly. Using
a level, mark the two lower
holes and drill pilot holes.
Insert #14 screws and, with
the mount level, tighten all
screws securely.
If Mounting To Wall Track
Lift the wall mount up to the
bottom of the TMD track,
or lower over the top of
the track if it’s easier. Slide
the clamp plates into the
groove in the TMD track.
Clamp
screws
ATTACH WALL PLATE TO TRACK
Once the wall plate is
at the desired height,
lock into place by
turning the 3 clamping
screws clockwise with
provided 5/32 hex key.
Track
clamp
plates
Cable Management
REMOVE COVERS FROM ARM
Using a Phillips head screwdriver, remove 3 screws
and slide front cover forward. Remove 4 screws from
the upper cover, and lift it off.
Remove the lower cover by lowering the arm into the
down position, removing the screws and sliding the
cover forward off of the arm.
WARNING - PINCH POINT:
Keep fingers away from the inner arm area where
the gas spring is located.
Front
cover
Lower
cover
Upper
cover
RUN WIRES & REATTACH ARM COVERS
Run monitor wires through top channel.
Run keyboard
wire through
lower channel
Snap black plastic bushing around exiting wires and
push bushing firmly into end cover port.
Replace upper and lower covers on the arm. DO NOT
use a power tool to tighten screws.
Slip wires from lower channel through
end cover port, then reattach cover to
the front of the arm. DO NOT use a
power tool to tighten screws.
