If you have any questions, please call 1-800-558-4435
SINGLE ARM ELITE
SINGLE ARM ELITE INSTRUCTIONS - rev 04/21/14 pjm
REMOVE ELITE ARM COVERS
TOP COVER:
Remove the long arm cover by
unscrewing the two 6-32 fl athead screws in the
center of the cover using a philips head
screwdriver.
END COVERS:
Remove the
end covers by unscrewing the two
10-24 fl athead screws using the 1/8 “ hex key.
MOUNT
DANGER!
1. Do not attempt to adjust your Elite arm until
everything you intend to mount to the arm is
mounted.
2. Arm must be completely horizontal (extended)
before adjusting the arm’s tension. Failure to do
so will damage the arm and void the warranty.
3. Never loosen or remove any of the shoulder bolts. Doing so
will cause the arm to immediately come apart with tremendous
force, and could cause serious injury.
4. If equipment requiring AC power is mounted to this unit, have a
certifi ed electrician inspect the installation.
5. Failure to install this unit according to these instructions will void
all ICW warranties. If installed incorrectly, ICW is not liable for any
damage or injury caused by the unit.
6. Do not use power tools to adjust arm tension. MUST be adjusted
by hand.
The Elite arm contains high
pr essur e gas springs. T he
following cautions MUST be
observed to avoid serious injury.
ATTACH ARM TO MOUNT
Follow instructions on the
following pages for your style
of mount.
Ceiling Mount.............
Page 2
Pole Mount ................
Page 2
Wall Mount .................
Page 3
Quicklink ....................
Page 3
Paralink......................
Page 4
RUN CORDS THROUGH ARM
Run cords through Elite end
frame and along cord channel.
MOUNT
When you
begin to place
arm covers, slip
cords through
end cover cord
ports.
Reattach black plastic
bushing around exiting
cords.
ADJUST ELITE ARM RESISTANCE
Extend the Elite
straight out as shown
before adjusting the
arm’s resistance. Be sure all
equipment is mounted on the arm
before adjusting. Use the T-handle
provided to adjust the arms’
resistance. Do not use
power tools to adjust.
ATTACH ELITE ARM COVERS
TOP COVER:
Attach the long arm cover by
screwing the two 6-32 fl athead screws in the
center of the cover using a philips head
screwdriver. DO NOT USE
POWER TOOLS IN
THIS STEP!
END COVERS:
Attach the
end covers by screwing the two
10-24 fl athead screws using the 1/8 “ hex key. DO
NOT USE POWER TOOLS IN THIS STEP!
MOUNT
Page 1 of 4
