SINGLE ARM ELITE INSTRUCTIONS - rev 04/21/14 pjm
SINGLE ARM ELITE
Page 2 of 4
IF USING
POLE MOUNT
Detach the pole mount from arm using the provided
5mm hex key. Separate the two sections of the pole
mount using the provided 5/32 hex key. Place around
the pole you are mounting to and fi rmly reassemble
the pole mount.
ATTACH POLEMOUNT TO POLE
a
b
c
ATTACH PIPE TO CEILING PLATE
Thread pipe into ceiling mount
and tighten set screw.
Tighten
set screw
once pipe is tightly
screwed in.
ATTACH PIPE TO ELITE ARM
Thread Elite
onto extension
pipe and tighten
set screw.
Tighten set screw
once Elite is tightly
screwed in.
IF USING CEILING MOUNT
MOUNT SQUARE CEILING PLATE
Using four 1/4 x 2” lag bolt
provided in hardware bag,
secure ceiling mount to a solid
wood surface or ceiling joist.
Use square pattern or inline
pattern, always being sure
to use all 4 bolts. Run cords
through center hole or the cord
management port. Be sure to
loosen set screw
BEFORE
attaching ceiling pipe.
Cord
management
holes
Loosen
set screw
in ceiling mount!
MOUNT INLINE CEILING PLATE
Firmly secure
ceiling mount to
solid ceiling joist
using four #14
wood screws
Loosen the set
screw in the
ceiling mount!
found in hardware bag,
being sure mount is level.
Be sure to loosen set screw
BEFORE
attaching pipe.
OR
