If you have any questions please call Toll Free 1-800-558-4435
Page 3 of 4
T2P2020 INSTALLATION 9/8/15 pjm
t2P2020 installation
iF attaCHinG to UltRa FliP-UP
iF attaCHinG to PaRalinK
Mount the Monitor
Attach Keyboard Tray
Attach VESA
to monitor
using four
4mm screws
in the
hardware
bag.
attaCH VEsa to
MonitoR (PaRalinK)
•
Remove beauty cap
on Paralink.
•
Remove screw using
3/16” hex key.
•
Slide keyboard tray
into Paralink.
•
Replace screw and
tighten.
•
Replace beauty cap.
Beauty cap
Screw
attaCH PaRalinK
•
Remove screws from
drop extension using
5/32” hex key.
•
Align holes in
keyboard tray with
screw holes in drop
extension.
•
Attach keyboard tray
using the provided
screws.
attaCH FliP UP
aDJUst PaRalinK tilt
Adjust monitor to
desired position with
ball VESA. Tilt monitor
50° in any direction.
Adjust monitor between
portrait and landscape
by rotating ball VESA.
Adjust monitor depth
by moving the paralink
forward or back then
tighting the depth
adjustment knob.
Depth
Adjustment
Knob
attaCH PaRalinK KEYBoaRD to MonitoR
Attach the paralink keyboard mount to the
monitor mount by using the 3/8-16 screw
and lock washer provided.
aDJUst Ball VEsa
tEnsion & HEiGHt
Use the slider knob to loosen the
slider to adjust the height of the
monitor on the Paralink.
Adjust the pivot tension of the ball
by gently and evenly tightening
or loosening the 4 screws on the
back of the ball VESA.
Slider Knob
Pivot tension
adjustment
screws
