T2 ARM INSTALLATION - rev 04/22/2014 pjm
TITAN ARM INSTALLATION
Page 2 of 3
ATTACH PARALINK KEYBOARD TO MONITOR
Attach the Paralink
Keyboard Mount to the
Monitor Mount by using
the 3/8-16 screw and lock
washer provided.
IF ATTACHING TO ULTRA FLIP-UP
IF ATTACHING TO PARALINK
ATTACH FLIP UP
1. Remove screws from
drop extension using
5/32” hex key.
2.
Align holes in keyboard
tray with screw holes in
drop extension.
3.
Attach keyboard tray
using the provided
screws.
ATTACH PARALINK
1.
Remove beauty cap on
Paralink.
2. Remove screw using 3/16”
hex key.
3.
Slide keyboard tray into
Paralink.
4. Replace screw and tighten.
5.
Replace beauty cap.
Beauty cap
Screw
MOUNT MONITOR
ATTACH KEYBOARD TRAY
ADJUST BALL VESA
TENSION & HEIGHT
Use the slider knob to
loosen the slider to adjust
the height of the monitor
on the Paralink.
Adjust the pivot tension
of the ball by gently and
evenly tightening or
loosening the four screws
on the back of the ball
VESA.
Slider Knob
Pivot tension
adjustment
screws
ADJUST
PARALINK TILT
Adjust monitor to desired
position with ball VESA.
Tilt your monitor 50°
in any direction. Adjust
your monitor between
portrait and landscape
by rotating ball VESA.
Adjust monitor depth
by moving the paralink
forward or back then
t i g h t i n g t h e d e p t h
adjustment knob.
Depth
Adjustment
Knob
ATTACH VESA TO MONITOR
(PARALINK)
Attach VESA
to monitor
using four 4mm
screws in the
hardware bag.
